Filter
Top Products
Effect parameters
80
PPDelay (STEREO PING PONG DELAY)
This is a stereo delay in which the sound bounces between left
and right.
1. TIME..................[0...1.75s]:Adjusts the delay time.
2. FEEDBACK........... [0...10]: Adjusts the feedback (delay repeats).
3. TONE..................... [0...10]:Adjusts the tone of the delayed
sound.
4. MODE....................... [1, 2]: Switches the order of output.
1: Output from L, 2: Output from R
5. MIX ........................ [0...10]:Adjusts the mix amount of the
delayed sound.
Room (ROOM)
This simulates the acoustics of rooms ranging from a small
studio-sized room to mid-sized rooms such as a garage.
1. TIME...................... [1...10]:Adjusts the length of reverberation.
2. -----(BLANK)......................
3. TONE..................... [1...10]:Adjusts the tone of the reverberation.
4. -----(BLANK)......................
5. MIX ........................ [0...10]:Adjusts the mix amount of the rever-
beration.
Hall (HALL)
This simulates the acoustics ranging from mid-sized to large
halls
* The parameters are the same as “ROOM.”
Spring (SPRING)
This simulates the spring reverb unit built into some guitar
amps.
* The parameters are the same as “ROOM.”
Plate (PLATE)
This simulates a plate reverb unit.
* The parameters are the same as “ROOM.”
NR/GATE BLOCK
The NR/GATE block is not displayed as an effect module,
but can be selected as part of the edit parameters.
1. NR
NR (NOISE REDUCTION)
This effect suppresses noise.
1. NR SEND...............[0...10]: Adjusts the depth of the effect.
2. -----(BLANK).....................
3. -----(BLANK).....................
4. -----(BLANK).....................
5. -----(BLANK).....................
It is not possible to turn “NR” off. If you do not want to
apply the effect, set “NR SEND” to “0.”
2. GATE
Gate (GATE)
This effect suppresses noise.
1. GATE THRESHOLD.[0...10]: Adjusts the level at which com-
pression is applied.
2. GATE ATTACK..........[1...10]: Adjusts the attack time.
3. GATE RELEASE.........[1...10]:Adjusts the release time.
4. -----(BLANK)...........................
5. -----(BLANK)...........................
It is not possible to turn the “GATE” off. If you do not want
to apply the effect, set “GATE THRESHOLD” to “0.”