Filter
Top Products
Effect parameters
75
4x12 Vin (4x12 VINTAGE)
This cabinet model simulates a closed back 30W enclosure
with four 12-inch speakers.
* The parameters are the same as “1x8 TWEED.”
4x12 Mdn (4x12 MODERN)
This cabinet model simulates a closed back 75W enclosure
with four 12-inch speakers.
* The parameters are the same as “1x8 TWEED.”
2. 4BAND EQ
Six types of 4-band graphic equalizer are provided, each with
different center frequency settings for the various bands.
LowEQ (LOW EQ)
Bands 1–4 correspond to 80 Hz, 120 Hz, 250 Hz, and 550 Hz.
1. 80Hz.................[–10...+10]:Band 1 level
2. 120Hz...............[–10...+10]:Band 2 level
3. 250Hz...............[–10...+10]:Band 3 level
4. 550Hz...............[–10...+10]:Band 4 level
5. LEVEL.................... [0...10]: Adjusts the overall level.
MidEQ (MID EQ)
Bands 1–4 correspond to 250 Hz, 550 Hz, 1 kHz, and 4 kHz.
* The parameters are the same as “LOW EQ.”
HighEQ (HIGH EQ)
Bands 1–4 corresponds to 640 kHz, 2 kHz, 6.4 kHz, and 12
kHz.
* The parameters are the same as “LOW EQ.”
WideEQ1 (WIDE EQ1)
Bands 1–4 correspond to 120 Hz, 250 Hz, 2 kHz, and 10 kHz.
* The parameters are the same as “LOW EQ.”
WideEQ2 (WIDE EQ2)
Bands 1–4 correspond to 100 Hz, 550 Hz, 1.2 kHz, and 4 kHz.
* The parameters are the same as “LOW EQ.”
WideEQ3 (WIDE EQ3)
Bands 1-4 correspond to 80 Hz, 125 Hz, 640 Hz, and 1.5 kHz.
* The parameters are the same as “LOW EQ.”
3. BASS CABINET
The Bass Cabinet block simulates a wide range of speaker and
cabinet characters, from vintage tube amps to modern solid
state amps.
When recording on the PXR4, this block can give your instru-
ment a sense of presence as though you were playing through
an amp.
Solid1 (SOLID1)
This is an all-around type of amp. It is also suitable for slap/
pop playing styles.
1. -----(BLANK).....................
2. MIX.........................[1...10]:Adjusts the output level when the
cabinet is used.
3. PRESENCE..... [–12...+12]:Adjusts the volume of the high-fre-
quency range.
4. -----(BLANK).....................
5. -----(BLANK).....................
If the sound is distorted, slightly lower the LEVEL and
PRESENCE settings.
Solid2 (SOLID2)
This amp has a hard and tight tone.
* The parameters are the same as “SOLID1.”
Tube1 (TUBE1)
This is an old-style amp with a warm low end response.
* The parameters are the same as “SOLID1.”