Appendices
85
→ Set the counter display to “FreeTime” and check the
amount of recordable time. (→p.56)
Is the bounce setting (“BOUNCE”) appropriate?
(→p.29)
→ If the bounce setting (“BOUNCE”) is set to “CONV,”
the recording will be created as a new song. (→p.51)
Can’t record two tracks simultaneously
The “EFFECT ASSIGN” (effect insert location) may
have been set to “GUITAR.”
→ If this is set to “GUITAR,” only one track can be
recorded simultaneously.
Input sound or recorded sound contains noise or distor-
tion
Is the [TRIM] knob raised to an appropriate level?
→ If the [TRIM] setting is too high the sound will distort;
if it is too low, noise will be heard. (→p.18)
If the effect input is distorted, make the following
adjustments.
Guitar/insert effect: Hold down the [SHIFT] key and
press the [DISPLAY] key, and select the “PRE” setting
for “DISPLAY.” Then use [TRIM] etc. to adjust the
input volume as high as possible without allowing
“CLIP” to light in the level meter.
Master effect: Adjust the faders and send level so that
“CLIP” for the master L/R track does not light.
Final effect: Adjust the faders so that “CLIP” does not
light for the master L/R track.
If the effect output is distorted, make the following
adjustments.
Guitar/insert effect: Adjust the effect parameters and
[TRIM] while listening to the sound.
Master/final effect: Adjust the effect parameters so
that “CLIP” for the master L/R track does not light.
Effect does not apply
Tuner mode may have been selected.
→ The effect will be bypassed (off) when the tuner is
selected.
Is the master volume of the effect program set to “0”
or close to “0”?
→ Press the [EFFECT] key, then press the [CURSOR]
right key several times to display “ProgMVol,” and
raise the volume setting.
Is the [TRIM] knob raised to an appropriate level?
→ If the [TRIM] setting is too low, the effect may not be
applied in some cases.
Guitar/insert effect does not apply
Is the effect insert location appropriate?
→ Hold down the [SHIFT] key and press the [EFFECT]
key, and set “EFFECT ASSIGN” to “GUITAR” or
“INSERT.” (→p.35)
It is not possible to use a guitar/insert effect on a play-
back track.
Master effect does not apply
Is the effect insert location correct?
→ Hold down the [SHIFT] key and press the [EFFECT]
key, and set “EFFECT ASSIGN” to “MASTER.”
(→p.35)
Is the send level from each track set to “0”or close to
“0”?
→ Press the [MIXER] key, and use the [CURSOR] keys to
raise the “Send-L” and “Send-R” send levels.