Korg Trinity Plus Musical Instrument User Manual


 
Overview
6
If you have inserted Insert Effects, the Send 1 and 2 parameters of P7 in Program Edit mode will become
effective (those of P5 will be ignored). If you have not inserted Insert Effects, the Send 1 and 2 parameters
of P5 in Global mode and P5 in Program Edit mode will become effective.
The Send 1 and 2 parameters are also used to set the level of signal appearing at output connectors 3 and
4.
Only the Master Effect sound will be sent to output connectors 3 and 4. If you wish to output dry sound
(without the Master Effects applied), set the Master Effect parameters of P8 in Program Edit mode to
Off. In this case, however, the Master Effect will not be applied to the signal at outputs 1 and 2.
If output connectors 3 and 4 are used for stereo output, you can set the stereo position of Send 1 and 2
using the Pan 3 and 4 parameters (P8 in Program Edit mode).
To set the Master Effect return level, use the Return 1 and 2 parameters (P8 in Program Edit mode).
If you check the check box located between Send 1 and Send 2 in the upper left corner of the LCD, the
serial routing of Modulation
Reverb/Delay will be added. That is, the Right modulation output will be
added to the Reverb/Delay input. In this case, you can also set the Return 1 and 2 parameters indepen-
dently.
Combination
Insert Effects
The Insert Effects selected in Program Edit mode are
not
used
in Combination Edit mode. Instead, you
can set Insert Effects for up to eight Timbres in a Combination.
Go to P7 in Combination Edit mode, and set the Insert Effects Off, size (1, 2, 4, 8), and grouping parame-
ters for each of Timbres 18.
If you wish to use a Programs Insert Effect settings by using the Copy function, rst select a size for the
corresponding Timbre equal to or greater than the size of the effects used in the Program.
You can route up to
three
Insert Effects for each Timbre
in series
. (If the Program is using a DrumKit, you
can use up to
four
effects
in series or parallel
.)
The total effect size for all the Timbres must be
eight or less
.
OSC1
Filter1
Amp1
OSC2
Filter2
Amp2
E1 E2 E3
Send1
Send2
PanWidth
Send1
Send2
Pan
Send1
Send2
Pan
Insert Effects
LEQ HEQ
Return1
Return2
Mixer
(Combination Edit P1)
Master Effects
Insert Effect Grouping
(Combination Edit P7)
Master Effects
(Combination Edit P8)
OUT1
OUT2
Insert Effect=Off
Combination
Reverb/Delay
Modulation
Low Gain High Gain
Pan1
Pan2
OUT3
OUT4
OSC1
Filter1
Amp1
OSC2
Filter2
Amp2
Send1
Send2
Pan
Send1
Send2
Pan
Timbre1
Timbre2
Timbre8
up to
E1 E2 E3
+
+
Send1
Send2
PanWidth
Insert Effects
+
+
+
Assigning / Grouping
Timbre to Insert Effects
Insert Effect=Off
in the case of
Insert Effect =Off
in the case of
Insert Effect =On
in the case of
Insert Effect =Off
in the case of
Insert Effect =On
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+