Filter
Top Products
13: Harmonic Chorus
30
13: Harmonic Chorus
This effect applies chorus only to higher frequencies. This can be used to apply a chorus effect to a bass
sound without making the sound thinner. You can also use this chorus block with feedback as a flanger.
a
LFO frequency [Hz] 0.02…20.00Hz LFO speed
Src None…Tempo Modulation source of LFO speed
Amt –20.00…+20.00Hz Modulation amount of LFO speed
b Pre delay [msec] 0.0…50.0msec Delay from the original sound
c
Depth 0…100 Depth of LFO modulation
Src None…Tempo Modulation source of the LFO modulation depth
Amt –100…+100 Modulation amount of the LFO modulation depth
d High/Low Split Point 1…100
Frequency split point between the low and high range
☞P.30
e Feedback –100…+100 Feedback amount of the chorus block
☞P.30
f High Damp [%] 0…100% Chorus block damping amount in the high range
g Low Level 0…100 Output level in the low range
h High Level 0…100 Output level in the high range (chorus)
i
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
d: High/Low Split Point This parameter sets the frequency that splits the low and high range. Only the
high range will be sent to the chorus block.
e: Feedback Sets the feedback amount of the chorus block. Increasing the feedback will allow
you to use the effect as a flanger.
In
Feedback
Wet / Dry
High Damp
Mono In - Mono Out
Low Level
High Level
High/Low Split Point
LFO: Triangle
Chorus/Flanger