Filter
Top Products
20: Envelope Phaser
37
size1
20: Envelope Phaser
This Phaser uses an envelope generator for modulation. You will obtain the same pattern of phasing each
time you play. You can also control the Phaser directly using the modulation source.
a
Manu Bottom
(Manual Bottom)
0…100
Sets the lower limit of the frequency range to which the
effect is applied.
☞P.24
b
Manu Top
(Manual Top)
0…100
Sets the higher limit of the frequency range to which the
effect is applied.
☞P.24
c
Sweep Mode EG, D-mod
Determines whether the phaser is controlled by the enve-
lope generator or by the modulation source.
☞P.34
Src None…Tempo
Modulation source that triggers the EG (when EG is
selected for Sweep Mode), or modulation source that
causes the phaser to sweep (when D-mod is selected for
Sweep Mode).
d EG Decay 1…100 Sets the EG decay speed.
☞P.34
e Resonance –100…+100 Sets the resonance amount.
☞P.35
f High Damp [%] 0…100%
Sets the resonance damping amount in the high range.
☞P.35
g
Wet/Dry
–Wet, –99…–1, Dry,
1…99, Wet
Sets the balance between the effect and dry sounds.
☞P.25, 35
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
Phaser
In
Resonance
Wet / Dry
Mono In - Mono Out
High Damp
EG Decay
EG
D-mod
Sweep Mode
D
-mod