Filter
Top Products
Overview
9
When you are adding Timbres/Tracks that use Single or Double mode Programs to a group of Tim-
bres/Tracks that use Drum mode Programs, they will be grouped (input) into Insert Effect Inst1 of
the Timbres/Tracks that use Drum mode Programs.
When you are adding Timbres/Tracks that use Drum mode Programs to a group of Timbres/
Tracks that use Single or Double mode Programs, only DrumKit sounds that have been assigned to
Inst1 in P5 of Global mode will be grouped (input) into the Insert Effects of the Timbres/Tracks
that use Single or Double mode Programs.
Master Effects
You need to set the Master Effects for each song in the Sequencer mode, since the Master Effects set in
Program Edit mode are ignored here.
The input levels of the Master Effects are set by Send 1 and 2.
Since the destination of the send routing changes depending on whether Insert Effects have been inserted
or not, the parameters will change accordingly.
If you have inserted Insert Effects, the Send 1 and 2 parameters of P7 in Sequencer mode will become
effective (those of P1–3 Mix 1–8 and P1–4 Mix 9–16 will be ignored). If you have not inserted Insert
Effects, the Send 1 and 2 parameters of P1–3 Mix 1–8 and P1–4 Mix 9–16 in Sequencer mode will be used
instead.
The Send 1 and 2 parameters are also used to set the level of the signal appearing at output connectors 3
and 4.
Only the Master Effect sound will be sent to output connectors 3 and 4. If you wish to output dry sound
(without the Master Effects applied), set the Master Effect parameters in P8 of Sequencer mode to “Off.”
In this case, however, you cannot apply the Master Effects to output connectors 1 and 2.
If the output connectors 3 and 4 are used for stereo output, you can set the stereo position of Send 1 and 2
using the Pan 3 and 4 parameters (P8 of Sequencer mode).
To set the Master Effect return level, use the Return 1 and 2 parameters (P8 of Sequencer mode).
If you check the check box between Send 1 and 2 located in the upper left corner of the LCD, the serial
routing of Modulation
→
Reverb/Delay will be added. That is, the Right modulation output will be
added to the Reverb/Delay input. In this case, you can still set the Return 1 and 2 parameters indepen-
dently.