Korg Trinity Plus Musical Instrument User Manual


 
18: Hold Delay
141
size4
c: RST Control Src
e: Manual RST Control
The RST Control Src parameter species the modulation source that controls the
reset operation. When you set this modulatoin source to On, or Manual RST
Control to RST On, you can erase what you recorded. If the Loop Time parame-
ter has been set to Auto, the loop time is also reset.
The effect is off when a value for the modulation source specied for the
RST Control Src parameter is 63 or smaller, and the effect is on when the
value is 64 or higher.
Hold procedure (when Loop Time = Auto)
Select the following options for each parameter:
1 a: Loop Time [msec] = Auto
b: REC Control Src = JS(+Y)
c: RST Control Src = JS(Y)
d: Manual REC Control = REC Off
e: Manual RST Control = RST On
It should be noted that all recordings will be deleted while Reset is On.
2 e: Manual RST Control = RST Off
Reset is cancelled and the unit enters Rec ready mode.
3 Push the joystick in the +Y direction (forward) and play a phrase you wish to
hold. When you pull the joystick to its original position, the recording will be
nished and the phrase you just played will be held.
Loop Time is automatically set only for the rst recording after resetting. If
the time length exceeds 2,700msec, Loop Time will be automatically set to
2,700msec. (If you have set a: Loop Time to 12,700msec, the specied loop
time will be used regardless of the time taken from pushing the joystick for-
ward until it is pulled back. However, the recording method remains the
same. The phrase being played while the joystick is pushed forward will be
held.)
4 If you made a mistake during recording, pull the joystick in the Y direction
(back) to reset. In this way, the recording will be erased. Repeat step 3 again.
5 The recorded phrase will be repeated again and again. You can use this to
create an accompaniment.
6 By pushing the joystick in the +Y direction (forward), you can also overdub
performances over the phrase that is being held.