Filter
Top Products
103
Using the Registration Buttons
Using the Registration Buttons
With the settings of Registration buttons [1]–[8] considered as one set, you
can store the Registration set to USB memory or User memory. We
recommend that complex panel settings or Registrations you wish to keep be
saved on USB memory. Furthermore, when you save Registrations created on
the ATELIER to USB memory, you can call up their settings on other ATELIER
Series instruments and use the Registrations the same way.
1.
Connect your USB memory to the external memory
connector.
If you want to save Registration data to a floppy disk, connect the floppy disk
drive to the Ext Drive connector.
Into the floppy disk drive, insert a floppy disk that was formatted by the
ATELIER.
2.
Touch <Registration> on the Main screen.
The Registration Load screen appears.
fig.03-09-3.eps
3.
Touch <go to Save>.
The Registration Save screen appears.
fig.03-09.eps
4.
Touch < > < > to select the desired media.
If you want to save the Registration to User memory, select “User.”
If you want to save the Registration to USB memory, select “Ext Memory.”
If you want to save the Registration to floppy disk, select “Disk.”
Saving Registration Sets
You can also open the
Registration Load screen by
pressing the [Registration]
button on the panel.
If you wish to assign a name
before you save, refer to
“Assigning a Name to a
Registration Set” (p. 101).
AT-500_e.book 103 ページ ２００８年７月２８日 月曜日 午後４時１７分