Filter
Top Products
232
Connecting with External Device
Connecting an External Display
Displays That Can Be Connected to This
Instrument
In general, a great many of the VGA monitors and multiscan
monitors that are available on the market are compatible
with this instrument. However, before you connect any
monitor, make sure it meets the following specifications:
Confirm that the display to be used is compatible with the
frequencies mentioned above. Using a display that is not
compatible with the above frequencies may result in
incorrect image output when images move, and in certain
cases may even damage the display.
Making the Connections
921
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
power on all devices before making any connections.
1.
Turn off the power to the ATELIER and the
display to be connected (p. 22).
2.
Connect your display to the ATELIER.
Use display cable (sold separately) to connect the
display to the RGB Out connector on the ATELIER.
3.
Switch on the ATELIER (p. 22).
4.
Switch on the connected display.
For more on handling the external display, refer to your
display’s owner’s manual.
Connecting an External Display
External Display
Display Cable
(commercial available)
Resolution
800 x 480 pixels
Horizontal scan frequency
31.5 kHz
Vertical scan frequency
60 Hz
Connector
3-row, 15-pin D-Sub type
Signal
Analog
NOTE
NOTE
NOTE
AT-500_e.book 232 ページ ２００８年７月２８日 月曜日 午後４時１７分