Filter
Top Products
243
Troubleshooting
Troubleshooting
Appendices
Problems with the Sound
Problem
Check Solution Page
Noise is heard in the sound
If there is a cell phone nearby, you
may hear noise from the ATELIER when
an incoming call or outgoing call
occurs, or during a conversation.
Keep the phone as far away as possible,
or turn off its power.
- - -
When the human voice “Jazz Scat”
is selected, playing dynamics do
not change the sound
“Initial Touch” is set to “OFF.”
Set “Initial Touch” to “ON.”
p. 198
When you release your fingers
from keys in the Lower keyboard,
the notes continue sounding
The Lower Voice Hold is at ON.
Turn “Lower Voice Hold” off.
p. 70
Sound is produced when you take
your finger off a key
You have selected a “Marimba Treml”
or “Banjo Treml” sound.
If you select a “Marimba Treml” or
“Banjo Treml” sound, a sound will also
be produced when you take your
finger off the key.
This is not a malfunction.
- - -
Some keys (of certain keyboard
parts) sound strange
You are playing notes outside the
recommended range of the voice.
This is not a malfunction.
- - -
Bass is heard even though you are
not playing the Bass Pedalboard
The Pedal [To Lower] button or the Bass
Split is at “ON.”
When the Pedal [To Lower] button is
ON, the Bass will be sounded by the
Lower keyboard.
In the Pedal part, press the Pedal [To
Lower] button or set “Bass Split” to
“OFF.”
p. 149
p. 152
When playing the same sound in
the Upper keyboard and Lower
keyboard, the volume is different
The “Initial Touch” setting is different
between the upper keyboard and
lower keyboard.
Set “Initial Touch” to the same setting for
both the upper keyboard and lower
keyboard.
p. 198
The sound is not played correctly
If you layer the same type of sound (for
example, Strings 1 and Strings 5), or
play an octave-shifted organ sound,
the timing at which you play a note or
the phase relationship between the two
sounds may affect the way in which the
sounds are heard, but this is not a
malfunction.
You are layering sounds of the same type
(e.g., Strings 1 and Strings 5).
Alternatively, you are playing an organ
sound with Octave Shift.
This is not a malfunction.
- - -
Even though you press only one
key, a multiple number of notes
sound
Harmony Intelligence is at ON.
Set “Harmony Intelligence” to “OFF.”
p. 125
Chord Intelligence is set to “ON.”
Set “Chord Intelligence” to “OFF.”
p. 80
Pitch is off
Transpose is in effect.
Simultaneously press the Transpose [-] [+]
buttons to cancel the transposition (the
Transpose [-][+] buttons’ indicators will
go out).
p. 117
The tuning is incorrect.
Adjust the standard pitch.
p. 210
While set for an octave shift, you are
playing keys beyond the
recommended range. This does not
indicate a malfunction.
Adjust the Octave Shift setting.
p. 64
Rotary effect is not be applied
Some sounds do not allow the rotary
effect to be applied.
This is not a malfunction.
- - -
AT-500_e.book 243 ページ ２００８年７月２８日 月曜日 午後４時１７分