Filter
Top Products
106
Using the Registration Buttons
Here’s how to recall a previously saved Registration set from the User memory
or USB memory into the memory of the ATELIER. Registrations can be selected
in the following three ways.
Loading a Set of Registrations (Load)
→
p. 106
You can load a “set” (a collection of settings for Registration buttons [1]–[8])
from USB memory or user memory.
Loading an Individual Registration (Load One)
→
p. 107
Recall the settings of one of the Registration [1]–[8] buttons.
Recalling the Order that the Registrations are Saved on the USB
Memory or User Memory (Load Next)
→
p. 122
Assign “RIGHT+ Load Next” to the foot switch, and recall Registration sets in
the order in which they are stored in USB memory or user memory.
1.
If you want to load a Registration from USB memory,
connect your USB memory to the External Memory
connector.
If you want to load a Registration from a floppy disk, connect the floppy disk
drive to the Ext Drive connector, and insert the floppy disk containing the
Registration into the floppy disk drive.
2.
Touch <Registration> on the Main screen.
The Registration Load screen appears.
fig.03-05.eps
Loading Previously Saved Registration Sets Into the ATELIER
Loading a Set of Registrations
NOTE
Be aware that when you load
Registrations from a USB
memory or user memory, the
Registrations that were
previously in internal memory
will be lost. It is a good idea to
save important Registrations to
USB memory or user memory
(p. 103).
You can also open the
Registration Load screen by
pressing the [Registration]
button.
When you touch <go to Save>,
the instrument jumps to the
Registration Save screen.
AT-500_e.book 106 ページ ２００８年７月２８日 月曜日 午後４時１７分