Filter
Top Products
20
Before You Start Playing
Attaching the Music Rest
1.
Insert the supplied screws for the music rest into the
screw holes located on the top of the instrument,
and lightly tighten them (two locations).
2.
Put the music rest between the screws and the
ATELIER’s body.
3.
While supporting the music rest with one
hand, secure it in place by turning the screws.
When attaching the music rest, support it firmly with one
hand to make sure that you don’t drop it. Be careful, so
you don’t get your fingers pinched.
Do not apply excessive force to the installed music rest.
Be sure to use the supplied screws for attaching the music
rest.
Before moving the organ, be sure to remove the music rest
to prevent accidents.
Removing the Music Rest
1.
To remove the music rest, support it with one
hand while loosening the screws.
2.
Remove the music rest.
After removing the music rest, don’t forget to retighten
the screws.
1.
Plug the speaker cable extending from the
stand into the Speaker connector located at
the rear of the AT-500’s bottom panel.
Pay attention to the shape of the speaker cable’s
connector, and insert it until you hear it click securely
into place.
Setting Up the Music Rest
Screw
Screw
NOTE
NOTE
NOTE
Connecting the Speaker Cable
Speaker Cord
Organ side
Speaker
box side
AT-500_e.book 20 ページ ２００８年７月２８日 月曜日 午後４時１７分