44
About CompactFlash
The SP-555 supports CompactFlash cards (type I) having a
capacity of from 32 MB up to 2 GB.
* You can’t use Type II cards such as Microdrives.
As of this date, Roland has verified that the SP-555 will work
correctly with the following memory cards.
* Even cards of the identical model may be unusable due to
differences in the specific design of the card or differences in
the conditions of use. We cannot completely guarantee all
operation with the above models.
When the SP-555 is shipped from the factory, special screws
are attached to the bottom panel at the locations marked by
★
. With the memory card cover attached, you can use a
Phillips screwdriver to remove these screws and reinstall
them in the CARD LOCK screw holes, making it impossible
to remove the memory card cover, and helping to prevent
theft of the CompactFlash card.
When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons or
controls get damaged.
When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
* You must use only these screws. Using any other screws will
cause malfunctions.
Recommended types of
CompactFlash
Manufacturer Model
Sandisk SDCFH-2048-903 (2GB)
SDCFX3-1024-903 (1GB)
IO Data CF115-256M (256MB)
CF115-512M (512MB)
Buffalo RCF-X128MY (128MB)
RCF-X256MY (256MB)
RCF-X512MY (512MB)
RCF-X1GY (1GB)
Hagiwara Sys-Com HPC-CF512ZP (512MB)
HPC-CF2GZP (2GB)
HPC-CF1GZ2F (1GB)
HPC-CF2GZ2F (2GB)
CompactFlash theft prevention
★
SP-555_e.book 44 ページ 2007年6月25日 月曜日 午前9時9分