Filter
Top Products
116
Messages and Error Messages
This section explains the meaning of the various error
messages and other messages that the TD-6 may display, and
describes the measures to take when these appear.
When [EXIT] appears as shown in the following figure, you
can press [EXIT] to dismiss the message.
fig.e-001_50
System and Battery Error
Messages
System Error!
fig.e-002_50
A problem has occurred with the internal system. Consult
your Roland dealer or nearest Roland Service Center.
Backup NG! Execute Reset All!
fig.e-003_50
Data in the TD-6’s memory may be corrupted.
The TD-6’s internal backup battery (the battery used for
saving User memory data) is fully drained; internal data has
been lost.
Consult your dealer or a nearby Roland service station to have
the battery replaced.
You can use the TD-6 temporarily by following the
instructions appearing in the display.
1. Press [ENTER ].
fig.e-003a_50
2. Press [ENTER ] once again.
Factory Reset is executed, enabling you to use the TD-6
temporarily.
Carrying out a Factory Reset deletes all of the current TD-6’s
data and settings, and returns them to the original factory
settings.
Backup Battery Low!
fig.e-004_50
The internal backup battery of the TD-6 (a battery that
maintains data in the user memory) has run down.
Contact your dealer or a nearby Roland service center to have
the battery replaced.
Messages and Error Messages
Related to Sequencers and
Songs
DATA OVERLOAD!
fig.e-008_50
Song contained an excessive amount of data, and as a result
could not be output successfully from MIDI OUT.
Try eliminating a track that has too much data.
999 Measure Maximum!
fig.e-009_50
The maximum number of measures for one song has been
exceeded, and as a result no more can be recorded to the song.
Not Enough Memory!
fig.e-010_50
Song recording or editing could not be carried out because
there was not enough internal memory.
Try deleting songs that are no longer needed (SONG/
DELETE; p. 91).
Changes Not Saved! Preset Song!
fig.e-011_50
This is a Preset song; changes to settings are not saved.