Filter
Top Products
78
Chapter 3 Global Settings for the TD-6 (SETUP/UTILITY, Factory Reset)
Backing Instruments Volume
Control (Backing Level)
This adjusts the volume of the backing part (Parts 1–4).
Raising the value will increase the volume. With a setting of
“0,” no sound is produced.
• This setting cannot be made in GM mode (p. 100).
• This volume setting is applied to all songs. Even when
songs are switched, the setting does not change.
• The volume level of the drum kit part is adjusted in the
“MasterVolume (Master Volume)” (KIT/COMMON/
MasterVolume; p. 68).
• Adjust the volume level of each part to correct the
volume balance among the parts (SONG/PART/Level; p.
89).
• Hold down [SHIFT] and press [SONG] to jump to this
screen.
fig.03-005_50
BackingLevel (Backing Level): 0–127
Muting Parts of a Song (Mute)
Select the part that is to be muted when [PART MUTE] is
pressed. [PART MUTE] lights while the muting is in effect.
This setting cannot be made in GM mode (p. 100).
Hold down [SHIFT] and press [PART MUTE] to jump to this
screen.
• This setting remains in effect even when songs are
switched and when the TD-6 is played using data from
an external MIDI device.
• All percussion instruments in the Preset songs (except for
Preset song #1 “DRUMS”) are recorded to the percussion
parts.
• Note numbers for muted drum instruments are
predetermined and cannot be changed. For more on
muting note numbers, refer to the “Preset Percussion Set
List” (p. 124).
• Performances using the TD-6 and pads are recorded as a
drum kit part.
fig.03-006_50
Mute:
SongDrum, SongDrm/Prc, UserDrmPart, Part1,
Part2, Part3, Part4, Part1-4
SongDrum:
Mutes only the drum instruments in the percussion part (the
percussion instruments still sound). This is convenient when
performing with Preset songs.
SongDrm/Prc:
All percussion part instruments are muted.
UserDrmPart:
Mutes the performance recorded to the drum kit part. This is
convenient when you want to perform along with songs you
have recorded yourself.
Part1, Part2, Part3, Part4:
The individual parts are muted.
Part1-4:
All Parts 1–4 are muted.
Tuning the TD-6 (Master Tune)
This tunes Parts 1–4 as a whole.
The reference pitch is 440.0 Hz.
Tuning of the drum kit part and percussion part instruments
is not affected by this setting.
fig.03-007_50 (SETUP-GENERAL-MasterTune)
MasterTune (Master Tune):
415.3–466.2 (Hz) (0.1 Hz steps)