Filter
Top Products
85
Chapter 5 Editing Songs (SONG Edit)
5
Even when “9 Perc Only” or “10 Special” is selected for the
percussion set, the buttons still light up according to the note
numbers.
• The correspondence between the lighted buttons and
note numbers is predetermined and cannot be changed.
• This function cannot be used with songs in which drum
performances are recorded to the drum kit part.
1. Select the song to be played back (p. 84).
2. Hold down [SHIFT] and press [PLAY ].
Playback of the song begins, and the buttons
corresponding to the performance of the percussion part
drums light up.
3. To stop the playback, press [STOP ].
Adjusting the Song Volume
You can adjust the volume of the song in the backing parts
(Parts 1–4) and the percussion part.
Raising the value will increase the volume. With a setting of
“0,” no sound is produced.
This volume setting is applied to all songs.
• Although drum performances in the Preset songs are
recorded to the “percussion part,” when you create your
own songs, what you play on the pads is recorded to the
“drum kit part.” The volume level of the drum kit part is
adjusted in the “MasterVolume” (Master Volume) (KIT/
COMMON/MasterVolume; p. 68).
• Adjust the volume level of each part to correct the
volume balance among the parts (SONG/PART/Level; p.
89).
1. While holding down [SHIFT], press [SONG].
The screen for setting the volume of the backing parts
appears.
fig.05-006_50
2. Press [INC/+] or [DEC/-] to make the setting.
3. Press [ ].
The screen for setting the volume of the percussion part
appears.
fig.05-007_50
4. Press [INC/+] or [DEC/-] to make the setting.
5. When you finish making settings, press [SONG]
to end the procedure.
fig.05-008_50
BackingLevel (Backing Level): 0–127
fig.05-009_50
PercPrtLevel (Percussion Part Level): 0–127
Muting a Selected Part
(Part Mute)
Each time [PART MUTE] is pressed the mute is alternately
turned on or off. [PART MUTE] lights when the mute is on.
At the factory settings, only percussion part drum tones are
muted.
fig.05-010.e
The part to be muted here is selected in “Mute” (SETUP/
UTILITY/Mute; p. 78). Hold down [SHIFT] and press [PART
MUTE] to jump to the settings screen.
Settings for muted parts are applied to all songs.
Muted Not muted
Lit Unlit