Filter
Top Products
89
Chapter 5 Editing Songs (SONG Edit)
5
Choosing Percussion Set and
Instruments (Percussion Set, Inst)
Select a percussion set for the percussion part and instruments
for Parts 1–4.
Percussion Part
The TD-6 features ten Preset percussion sets that are ready to use.
You cannot change the content of the Preset percussion sets.
To see which percussion sets can be selected here, refer to the
“Preset Percussion Set List” (p. 124).
Percussion Set:
A collection of a number of percussion instruments. A
different percussion instrument is assigned to each note
number, so multiple instruments can be used at one time.
fig.05-025ai.e
Set (Percussion Set): 1–10
Parts 1–4
You can select all internal tones in sequence, including
variation tones.
You can switch instrument groups for the backing instruments
by holding down [SHIFT] and pressing [INC/+] or [DEC/-].
To see which backing instruments and instrument groups can
be selected here, refer to the “Backing Instrument List” (p.
126).
Instrument numbers correspond to the program numbers (1–
128).
Variation Tone:
This is a type of tone that varies slightly from that of the
instrument number. The number of variation tones varies
with the instrument number.
fig.05-024ai.e
Backing Inst: 1–128
Adjusting the Part Volume (Level)
Specifies the volume at each point. Raising the value will
increase the volume. With a setting of “0,” no sound is
produced.
Adjust here to balance the volume levels of the different parts.
fig.05-026_50
LEVEL: 0–127
Percussion Set Number
Percussion Set Name
Display When a Variation
Tone is Used
Instrument Number
Instrument Name
Capital sounds
Variation sounds