Filter
Top Products
TASCAM 2488neo 11
1 − Introductions
About finalizing
Although audio data may be written on a CD-R or CD-RW
disc, a standard CD player will not be able to read the data
(i.e. play back the audio) until a final *TOC has been writ-
ten at the start of the disc.
*TOC: Table of contents
Information of recorded data, which contains titles, starting
and ending addresses, and etc..
The process of writing this table of contents is known as
“finalizing.” Once this has been done, no further data can
be written to the disc. See “Finalizing the disc” on page 76
for details. In the case of a CD-RW disc which has been
finalized, the whole of the disc may be erased, or the disc
may be “refreshed,” and the disc re-used.
About CD-R and CD-RW discs
CD-R discs can be recorded once only. Once they have
been used for recording, they cannot be erased or re-
recorded. However, if space is available on the disc, addi-
tional material can be recorded. The packaging of CD-R
discs will include one of the following logos:
By contrast, a CD-RW disc can be used in much the same
way as a CD-R disc, but the last track or tracks recorded
can be erased before the disc has been “finalized,” and the
space on the disc can be re-used for other recordings. The
packaging of CD-RW discs will include one of the follow-
ing logos:
High Speed
However, you should note that an audio CD created using
a CD-RW disc may not play back satisfactorily on every
audio CD player. It will, naturally, be playable on the
2488neo. This is in no way a limitation of the 2488neo
itself, but of the difference between the different types of
media and the methods used to read them.
There are precautions that you should take when handling
CD-R and CD-RW discs.
Avoid touching the recording (non-label) side of a
•
disc on which you will be recording. Recording on
a disc requires a cleaner surface than playing back,
and fingerprints, grease, etc. can cause errors in the
recording process.
CD-R and CD-RW discs are sensitive to the effects of
•
heat and ultraviolet rays. It is important that they are not
stored in a location where direct sunlight will fall on
them, and which is away from sources of heat such as
radiators or heat-generating electrical devices.
Always store CD-R and CD-RW discs in their cases to
•
avoid dirt and dust accumulating on their surfaces.
When labeling CD-R and CD-RW discs, always use a
•
soft oil-based felt-tipped pen to write the information.
Never use a ball-point or hard-tipped pen, as this may
cause damage to the recorded side.
Always keep the recording sides of the discs away from
•
grime and dust to avoid a reduction in sound quality.
To clean a disc, wipe gently with a soft dry cloth from
the center towards the outside edge. Do not use thinner,
gasoline, benzene or LP cleaning fluid, as these will
damage the disc and cause the disc unplayable.
Do not put labels or protective sheets on the discs and do
•
not use any protective coating spray.
If you are in any doubt as to the care and handling of a
•
CD-R and CD-RW discs, read the precautions supplied
with the disc, or contact the disc manufacturer directly.