Filter
Top Products
48 TASCAM 2488neo
7 − Recorder
To position the playback point precisely, you can “jog” the
playback position, using the dial. As you move backwards
and forwards through the recording, you can hear the
recorded sound at slow speed, either backward or forward,
depending on the direction you are turning the dial.
NOTE
The 2488neo can locate a position with an accuracy
of 1/10 frame. The length of 1 frame depends on the
frame rate (24–30 frames per second). At this speed,
1/10-frame accuracy is equivalent to 1/300-second –
1/240-second accuracy.
1 Position the playback point to the rough position
where you want the final point to be.
2 Press and hold the STOP key and press the PLAY
key. The transport enters JOG mode and the JOG
indicator lights. The display shows a view of the
waveform of the currently selected track at the
current playback position.
3 Press the SELECT key of the track that you want to
view (pressing the SELECT key of any of the stereo
tracks [13/14, 15/16, 17/18, 19/20, 21/22, 23/24] alter-
nates between viewing the odd- and even-numbered
tracks). The display changes to the waveform of that
track.
4 Use the Ó and Á cursor keys to zoom out and in
respectively horizontally.
In other words, pressing the Á key will increase the
amount of space on the screen taken by a certain
amount of time, and pressing the Ó key will make
the same amount of time take less space on the
screen.
The three zoom levels available are: x 1, x 2 (allow-
ing approximately single-frame accuracy in adjust-
ment), and x 32 (allowing approximately an accura-
cy of about 10 sub-frames). The resolution is shown
below the time display.
5 Use the § and ¶ cursor keys to adjust the vertical
scale (the way that the volume of the sound is shown).
The zoom levels here are x 1, x 2, x 4, x 8, x 16 and x 32.
Pressing the § key increases the vertical scaling of the
display, and pressing the ¶ key decreases the scale.
TIP
If you cannot see any waveforms when you first enter
this display, press the § key to zoom the volume so
that you can see the quiet passages.
6 Use the dial to move to the desired playback position.
You can monitor the “jogged” sound of the selected
track through the monitoring system.
TIP
To move past the edge of the screen, press and hold
the F FWD or REW keys to play the tracks forwards
or backwards at normal speed for a rough position.
When you release the keys, the playback will stop.
7 Press STOP (or YES/ENTER or NO/EXIT) to return
to the home screen, with the playback position now
being the point which has just been set.
The home screen now shows the playback position
set with the JOG operation.
NOTE
Because only one track can be jogged at a time, only
one track of a stereo pair can be heard at a time in this
mode. If it is difficult to hear the track, you may want
to monitor in mono (see “Monitoring” on page 36).
Jog positioning