Filter
Top Products
IntroductionPanel TourSetupPlayingCreating
and Storing
17
SWITCHING EFFECTS ON/OFF
As an example, here’s how you can switch the pedal and insert effects on/off for
the current program.
1. If the Effect ON/OFF pedal LED is dark, you’re in Program Select mode. Press
the Effect ON/OFF pedal to change to Effect On/Off mode.
Program LEDs 1–4 indicate the on/off status of the pedal, modulation, delay,
and reverb effects.
2. If program LED 1 is lit, the pedal effect is ON. When you press program select
pedal 1, the pedal effect will turn off and LED 1 will go dark.
3. If the INSERT button LED is dark, your guitar signal is not being sent through
the external effect. When you press the BANK DOWN pedal, the external
effect send/return will be turned ON, and the INSERT switch LED will light.
NOTE: If you haven’t connected an external effect processor to the INSERT SEND/
RETURN jacks, the INPUT signal will bypass the insert circuit whether the INSERT
switch LED is lit or dark.
A/B CHANNEL HOLD
You can specify whether the channel (A or B) memorized in the program will be
automatically selected when you select the program (OFF), or whether your cur-
rent channel selection (A or B) will be maintained even when you select a different
program(ON).
1. Press the GLOBAL button, and use the √√
√√
, ®®
®®
buttons to access the “CH
HOLD” display.
2. Use value knob 6 or the ▲, ▼ buttons to change the setting.
NOTE: With the factory settings this is set to “OFF.”