Filter
Top Products
TunerPedals
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
57
be applied to the parameter at a “factor” (i.e., multiple) of 1/6, 1/4, 1/3, 1/2, 2/3, 3/4, 1,
4/3, 3/2, 2, 3, or 4, according to the setting of the FACTOR parameter (value knob 2).
NOTE: The maximum spacing of your taps can be no more than ten seconds.
NOTE: If you’ve assigned a parameter other than MOD TAP or DLY TAP, the FAC-
TOR setting does nothing.
EFFECT CONTROL
NOTE: If you haven’t selected an applicable effect, nothing will be controlled.
1. Press the CONTROL button to make it blink.
2. To select the control target, use the ▲, ▼ buttons or turn value knob 1.
3. If you’ve selected MOD TAP or DLY TAP, press the ®®
®®
button or turn value knob
2 to make the name display read “FACTOR”. Here you can specify the propor-
tion of SPEED or TIME in relation to the interval of your taps. For example if
you set DLY TAP as the target, and FACTOR to “1-4,” the delay time will be set
to 1/4th of the duration between taps.
4. Press the EXIT button to return to the mode you were in.
ADJUSTING THE SENSITIVITY OF THE PEDALS
If you notice that advancing the ToneLabSE’s expression pedal does not reach the
full effect or volume even when the Min and Max parameters are set to the mini-
mum and maximum settings, or that returning the expression pedal does not reach
the minimum effect or volume, you will need to perform the following adjustment so
that ToneLabSE’s expression pedal will be able to reach its full range of operation.
NOTE: When adjusting the sensitivity, you must use your hand to operate the
pedal. Accurate adjustment may not be possible if you use your foot to operate it.
EXPRESSION PEDAL 1
1. Turn the power OFF.
2. While holding down the EXPRESSION button and the CHAIN button, turn the
power on. The name display indicates EXP1 MIN.
3. Slowly return expression pedal 1 toward yourself (pedal
back), and take your hand off the pedal when it stops.
4. Press the GLOBAL button. The name display indicates EXP1 MAX.
• “FLN TRIG” LFO START TRIGGER of the CLASSIC FLANGER effect
•“ROT SPD” SPEED SW of the ROTARY effect
• “HOLD DLY” HOLD of the HOLD DELAY effect