Filter
Top Products
TunerPedals
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
63
“DUMP ALL” (Dump all data): All of the ToneLabSE’s data will be dumped.
5. Put the receiving device in a mode in which it can record the data dump.
NOTE: For details, refer to the owner’s manual of the device that will receive the
data dump.
6. Press ToneLabSE’s WRITE button (3.6) to begin transmitting. When transmit-
ting is completed, the display will indicate “COMPLETE,” and you will return to
the screen of step 4. (While “DUMP ALL” is being transmitted, the display will
indicate “SEND.”)
NOTE: While data is being transmitted, do not touch the buttons or knobs of
ToneLabSE or its foot controller, and never turn off the power.
RESTORING
1. Connect the transmitting device’s MIDI OUT to ToneLabSE’s MIDI IN.
2. Set the transmitting MIDI device and ToneLabSE to the same MIDI channel. If
ToneLabSE will be receiving data that was previously transmitted to the exter-
nal MIDI device, select the same MIDI channel as was used when transmitting.
3. Transmit the data dump from the external device.
While ToneLabSE is receiving all data, its display will indicate “RECEIVE.”
When reception has been successfully completed, it will indicate “COM-
PLETE.” If an error occurs, the display will indicate “ERROR”; in this case, try
transmitting the data again.
NOTE: For details, refer to the owner’s manual of the device that will be transmit-
ting the data dump.
NOTE: While data is being transmitted, don't touch the ToneLabSE's buttons, ped-
als, or knobs, and never turn off the power.
4. If you received data for a single program, select the save-destination bank and
program, and save the data. (p.22)
NOTE: The program data will not be written into ToneLabSE’s program memory
unless you store it.
If you received data in Manual Mode, settings other than for the amp section will be
overwritten automatically, so you don’t need to store the settings yourself. (Since
the settings of the amp section are determined by the physical positions of the
selectors and controllers, they will not change.)
HINT:
If ToneLabSE receives all data, all of its data will be overwritten automatically.
However, the data currently being edited (i.e., the edit buffer) will not be affected.