Filter
Top Products
56
“EXP1INIT” lets you specify whether the control data for expression pedal 1
(i.e., the position of the pedal) will be maintained when you switch programs.
(“EXP2INIT” does the same for expression pedal 2.)
Use the ▲, ▼ buttons to change the setting.
If this is turned “OFF”; the instant you switch programs, the parameter that is
specified as the expression target will change to the current position of the pedal.
If this is turned “ON”; the parameter will be initialized to the same setting as
when the program was saved (i.e., the control data will be initialized).
Press the EXIT switch to exit this editing operation and return to the mode in
which you were.
NOTE: The “EXP1INIT” and “EXP2INIT” settings are not saved in a program; these
settings apply to all programs in common, and the setting is saved automatically.
CONTROL SWITCH SETTINGS
You can make the following control pedal settings independently for each program.
Press the CONTROL button to make it blink, and use value knob 1 to select the
effect you want to control.
SWITCHING EACH EFFECT ON/OFF
NOTE: The CONTROL button LEDs indicate the on/off status.
USING TAP TEMPO TO SET A PARAMETER
NOTE: The CONTROL button LED will blink at the tempo you specify.
FACTOR VALUE KNOB 2 SETTING
If the MODULATION effect’s SPEED parameter or the DELAY effect’s TIME parame-
ter are assigned to a control pedal, you can set the MODULATION effect’s LFO
SPEED or the DELAY effect’s DELAY TIME by the interval at which you press the con-
trol pedal twice. When you do so, the interval at which you actually press the pedal will
• “I/ON OFF” External effect insertion on/off
• “P/ON OFF” Pedal effect on/off
• “A/ON OFF” Amp model on/off
• “C/ON OFF” Cabinet effect on/off
• “M/ON OFF” Modulation effect on/off
• “D/ON OFF” Delay effect on/off
• “R/ON OFF” Reverb effect on/off
• “MOD TAP” Use TAP TEMPO to set the SPEED parameter of the
modulation effect
• “DLY TAP” Use TAP TEMPO to set the TIME parameter of the delay
effect