Filter
Top Products
22
STORING A PROGRAM
When your tweaking has resulted in a sound you’re happy with, store (write) it!
1. Press the WRITE button (3.6).
The name display (3.8) shows “*WRITE*” and the bank display (5.1) and pro-
gram LEDs 1–4 will blink.
2. Use value knob 6 (2.2) or the ▲, ▼ buttons (3.1) to select the bank you want to
use, and use the √√
√√
, ®®
®®
buttons to select the destination program (1–4).
For example if you want to store your program in 9-1 (bank 9, program 1), use
value knob 6 or the ▲, ▼ buttons to make the bank display show “9,” and then
use the √√
√√
, ®®
®®
buttons to make the program 1 pedal LED blink.
HINT: You can also select the store-destination program by using the BANK UP/
DOWN buttons or the program 1–4 select buttons.
3. Press the WRITE button (3.6) once again.
The name display will indicate “COMPLETE.” Your program is now stored, and
you’ll be back in Program Select mode.
NOTE: The program is written over the previous contents of that bank/program.
The program that previously occupied the number you selected in step 2 will be
erased.
NOTE: If you decide not to store your new program, press the EXIT button (3.7) to
cancel the procedure.
NOTE: If you switch to a different program or turn off the power without storing the
program you edited, your changes will be lost.
RESTORING A SETTING TO ITS ORIGINAL VALUE (ORIGI-
NAL
VALUE)
The Original Value icon in the value display (3.10) gives you a way to find out the
parameter values that are stored in a program.
When you are using a knob or button to change the value of a parameter, the
ORIG (original value) icon will appear when the value you are adjusting matches
the “original value” stored in the program.
HINT: So, you’re flipping through the programs on your new ToneLabSE, and you
come across one you really like. It’s easy to find out exactly what settings are
dialed in to get such an awesome tone — just use this Original Value display fea-
ture!