Filter
Top Products
vii
15.
ToneLabSE provides a PEDAL effect that is placed before the amp, and MOD-
ULATION, DELAY, and REVERB effects that are placed after the cabinet.
For example if you want use the PEDAL effect TREBLE BOOST, turn the
PEDAL selector to select TREBLE BOOST. The PEDAL parameter LED of the
edit section will blink, indicating the parameter line (the region listing the
parameter names). Also, the LEDs below the value knobs will light, indicating
the location of the knobs that you can use to control TREBLE BOOST. Now
turn value knobs 1, 2, and 3 to adjust DRIVE, LEVEL, and TONE respectively.
You can edit other effects using the same procedure.
HINT:
Some effect settings may cause unwanted distortion (if there is such a
thing!!). If this happens, lower the CH VOLUME.
HINT:
For an illustration, look at area in the top panel diagram at the end of this
manual.
2