Filter
Top Products
42
6. TEXTREM STEREO IN/STEREO OUT 2
This models the popular tremolo circuit that’s built into the BLACK 2x12 model. The
SPREAD setting lets you produce a panning effect that spreads to left and right.
7. ROTARY MONO IN/STEREO OUT 2
This models a stereo rotary speaker. When you adjust the speed, it will take a cer-
tain amount of time for the specified speed to be reached – just like on an actual
rotary speaker. This is because it takes several seconds for the motor that creates
the rotation to accelerate or decelerate.
[5] “MODE” S1, S2, P1, P2,
P3
Specifies the connection and LFO for PHASER
1/2.
S1:PHASER 1/2 are connected in series.
S2:PHASER 1/2 are connected in series and
their LFOs are synchronized to create a
pseudo-twelve-stage phaser.
P1:PHASER 1/2 are connected in parallel.
P2:PHASER 1/2 are connected in parallel, and
their LFOs are synchronized (Stereo mode).
P3:PHASER 1/2 are connected in parallel, and
their LFOs are synchronized in opposite
phase (Stereo mode).
NOTE: If P2 or P3 is selected, the speed is adjusted by the SPEED 1
knob.
[1] “SPEED” 1.00–10.00 [Hz] *Adjusts the tremolo speed.
[2] “DEPTH” 0.0–10.0 * Adjusts the tremolo depth.
[5] “SPREAD” 0.0–10.0 * Adjusts the left/right spaciousness.
[1] “SPEED 1” 0.80–10.0 [Hz] *Adjusts the rotational speed of the speaker. If
you assign “ROT SPD” to the CONTROL
pedal, this will be the SLOW speed. This knob
is effective even if you’re not using the CON-
TROL pedal. (
p.56
Control pedal settings)
[2] “DEPTH” 0.0–10.00 *Adjusts the modulation depth.
[4] “SPEED 2” 0.80–10.0 [Hz] *Adjusts the rotational speed of the speaker. If
you assign “ROT SPD” to the CONTROL
pedal, this will be the FAST speed. This knob
will not function if you’re not using the CON-
TROL pedal. (
p.56
Control pedal settings)
[5] “ACCEL” 1.0–10.0 *Adjusts the time it takes for the rotational
speed to change. With higher settings, the
change will take more time.