Filter
Top Products
TunerPedals
MIDI/DIGITAL
Factory
settings
Trouble-
shooting
Spec.Program
List
61
1. Press the GLOBAL button (3.4).
2. Press the √√
√√
, ®®
®®
buttons (3.2) to make the name display (3.8) read “CCHG I/O.”
3. Specify whether all control change messages will be transmitted or received.
Use value knob 6 (2.2) or the ▲, ▼ buttons (3.1) to make your choice.
“On” allows transmitting and receiving. “OFF” disables transmitting and receiv-
ing.
NOTE: If this setting is “OFF,” no control change messages will be transmitted or
received even if you specify individual control change numbers in step 4.
4. Simultaneously press both √√
√√
, ®®
®®
buttons (3.2) to access the screen where you
can set control numbers individually. Use the √√
√√
, ®®
®®
buttons to select each con-
troller.
The controllers will be selected in the following order.
5.
For each controller, specify whether ToneLabSE will transmit and receive control
change messages. If you want ToneLabSE to transmit and receive messages for
a controller, specify the control change number. Select a controller, and use
value knob 6 (2.2) or the
▲
,
▼
buttons (3.1) to make the desired setting.
“OFF”: Control change messages will not be transmitted or received.
“CC00”–“CC95”: When you operate a controller, messages of the specified
control change number 00–95 will be transmitted. Similarly, ToneLabSE will be
controlled when it receives messages of the same control change number
from an external MIDI device.
6. To return to the screen where you specify transmit or receive for all control
change messages, press both √√
√√
, ®®
®®
buttons (3.2) simultaneously.
PARAMETER CHANGE (GLOBAL “SYEX OUT”)
When you operate ToneLabSE’s knobs or buttons to edit the value of a parameter,
system exclusive such as parameter changes are transmitted.
If you want ToneLabSE’s parameters to be transmitted to an external device, turn
the “SYEX OUT” setting “On.” Normally, you will turn “SYEX OUT” on when using
the Sound Editor.
This setting specifies whether ToneLabSE will transmit parameter changes.
“EXP1 PDL” Expression pedal 1 control
“EXP2 PDL” Expression pedal 2 control
“CTRL PDL” Control pedal on/off
“VOL PDL”: VOLUME pedal control
“TAP SW”: TAP switch on/off
“PEDAL FX”: PEDAL effect on/off
“MOD FX”: MODULATION effect on/off
“DELAY FX”: DELAY effect on/off
“REVRB FX”: REVERB effect on/off
“INSRT FX” External effect on/off
“A/B CH” Channel A/B