Filter
Top Products
Reference [Other Functions]
ZOOM HD8/HD16
171
4. Turn the dial to change the setting to a value
from 1 – 3.
5. When the setting is complete, press the
[EXIT] key several times to return to the main
screen.
To check the system software version of the HD8/HD16,
proceed as follows.
1. From the main screen, press the [PROJECT/
UTILITY] key.
The indication “REC UTILITY” appears on the first line of the
display, and “PROJECT” is shown on the second line.
2. Use the cursor left/right keys to bring up the
indication “SYSTEM” on the second line of
the display, and press the [ENTER] key.
The display indication changes as follows.
3. Use the cursor left/right keys to bring up the
indication “SYSTEM VERSION” on the
second line of the display, and press the
[ENTER] key.
The current system version is shown.
To return to the main screen, press the [EXIT] key several
times.
This section describes how to test and restore the integrity of
data on the internal hard disk of the HD8/HD16, and how to
perform other hard disk maintenance functions.
The procedure for hard disk maintenance is the same for most
operations. The basic steps are described below.
1. Turn power to the HD8/HD16 off. While
holding down the [CLEAR] key in the control
section, turn power on again.
The HD8/HD16 starts up in “HDD utility mode” which serves
for performing special functions.
2. Use the cursor left/right keys to select the
desired command.
The following commands are available.
●
INIT ALL (All Initialize)
Format the hard disk and restore system files and various
data necessary for operation. All existing projects will be
erased.
●
INIT FACTORY (Factory Initialize)
Restore system files and various data necessary for
operation. Data created by the user will not be erased.
●
SCAN DISK
Test and repair the integrity of data stored on the internal hard
disk.
3. Press the [ENTER] key to execute the
command.
Subsequent display indications and operation steps differ for
the individual commands. See the respective section below.
4. When the command has been executed, turn
the unit off and then turn it on again.
The HD8/HD16 will operate in normal mode.
Checking the system
version
SYSTEM 1/7
SYSTEM 1/7
>FOOT SWITCH
>FOOT SWITCH
ZOOM HD16
ZOOM HD16
Ver:1.00
Ver:1.00
Hard disk maintenance
Basic maintenance procedure
HDD UTILITY 1/3
HDD UTILITY 1/3
>INIT ALL
>INIT ALL