Filter
Top Products
Quick Tour
ZOOM HD8/HD16
31
3. Repeatedly press the [SELECT] key, until the
parameter to adjust is shown.
The display shows the selected parameter.
The [SELECT] key gives access to the following track
parameters.
Parameters marked with (*) can be switched on and off.
The currently selected track parameter is shown by the lit
parameter select indicator to the left of the display.
4. Turn the parameter knob for the track whose
parameter value you want to adjust.
The display switches to the track that is being adjusted, and the
value of the track parameter selected in step 2 changes.
HINT
•To adjust a track parameter for the drum/bass track, press the
[RHYTHM] status key to select the drum track (key lit in green)
or rhythm track (key lit in red), and then operate the knob.
• For stereo tracks, the parameter change applies to both tracks.
For parameters marked with a (*) in the table at left, you can
press the [ENTER] key to switch the parameter on or off for
the most recently adjusted track. For example, if you press the
[ENTER] key while adjusting EQ HIGH GAIN for track 3, the
display changes as follows, and high-frequency EQ for that
track is set to off.
HINT
It is also possible to first select a track with the left/right cursor
keys or the status keys and then switch the parameter on or off.
5. Repeat steps 3 – 4 to adjust other parameters
Parameter Setting range Description
EQ HI GAIN (*) -12 – +12dB
Adjusts high
frequency range boost/
cut.
EQ MID GAIN (*) -12 – +12dB
Adjusts mid frequency
range boost/cut.
EQ LOW GAIN (*) -12 – +12dB
Adjusts low frequency
range boost/cut.
CHORUS DELAY
SEND LEVEL (*)
0 – 100
Adjusts level of signal
sent from track/input
to chorus/delay effect.
REVERB SEND
LEVEL (*)
0 – 100
Adjusts level of signal
sent from track/input
to reverb effect.
SUB-OUT SEND
LEVEL (*)
<< only>>
0 – 100
Adjusts level of signal
sent from track/input
to STEREO SUB-
OUT jack.
PAN L100 – R100
Adjusts panning for
the track/input. For
stereo tracks, this
adjusts the left/right
balance.
Track1
Track1
EQ HI G=-10dB
EQ HI G=-10dB
Track1
Track1
EQ MID G=0dB
EQ MID G=0dB
Track1
Track1
EQ MID G=0dB
EQ MID G=0dB
Parameter select
indicators
Lit
Parameter knob 3
Track3
Track3
EQ HI G=-10dB
EQ HI G=-10dB
[ENTER] key
Track3
Track3
EQ HI G=-10dB
EQ HI G=-10dB
Track3
Track3
EQ HI Off
EQ HI Off