Filter
Top Products
10
Contents of the package
■
Rackmount adaptors (two pcs.)
Use this when you want to install the UA-1000 in an audio rack. Two rack ears are included.
■
Ferrite Core (for 230V and 240V)
The ferrite core should be attached to the cord of your headphones.
Attaching the rackmount adaptors
If you want to install the UA-1000 in a rack, attach the rackmount adaptors as shown in the diagram.
fig.angle
1. Remove three screws (on each side)
from the right and left panels of the
UA-1000.
2. Using the screws you removed in
step 1, attach the rackmount
brackets to the UA-1000.
* You must use the screws that you
removed. Do not use any other screws.
Attaching the Ferrite Core
Before using headphones, make sure to attach the ferrite core.
If you will be using headphones, please follow the instructions below to clamp the supplied ferrite core over
the cord. Afterwards, make sure to leave it on the cord, since it serves in blocking electromagnetic noise.
fig.ferraite-1
1. Open the ferrite core and position it over the cord.
* Make sure to position it so it’s close to the plug.
fig.ferraite-2
2. Wrap the cord around the ferrite core; one turn is enough.
fig.ferraite-3
3. Close it firmly; you should hear a distinct sound as it clicks shut.
* Take care not to get your fingers pinched when attaching the ferrite core.
* Make sure you don’t apply undue force and damage the cord when clamping on
the ferrite core.
UA-1000_e.book 10 ページ ２００３年８月６日 水曜日 午前１１時５２分