Filter
Top Products
42
Synchronization settings
ADAT Input mode
Simultaneously press the ADAT mode switch and the External Clock mode switch. The peak indicator will
light in orange, and the UA-1000 will be in ADAT Input mode. The outputs will operate in the same way as
in ADAT Output mode.
* If the word clock input connector is connected, the word clock input connector will take priority for
synchronization. If the UA-1000 is operating in synchronization to the word clock, the ADAT compatible
device connected to digital input must be synchronized to the word clock.
* Set the sampling frequency select switch and the sampling frequency setting of your software to 44.1 kHz or
48 kHz. If a setting other than 44.1 kHz or 48 kHz is selected, ADAT mode will not be available; pressing
the ADAT mode switch will not cause the ADAT mode switch to light.
* If the external clock switch is blinking, synchronization has not been achieved. The UA-1000 will not be able
to record or play back correctly. Please check the settings of the connected equipment.
Possible reasons for problems
• The digital signal from the connected ADAT compatible device is not being received correctly.
• If a word clock is being input to the word clock input connector in ADAT mode, the word
clock signal is not being received correctly, or the sampling frequency of the word clock is not
44.1 kHz or 48 kHz.
* Turning off the power of the UA-1000 will not change the setting of this switch.
* The coaxial digital and analog input jacks will not be available.
fig.adat-off
While in ADAT Input mode, pressing the ADAT switch will exit
ADAT mode and enter External Clock mode.
fig.adat-ext-off
While in ADAT Input mode, pressing the External Clock mode switch
will exit ADAT Input mode and enter ADAT Output mode.
UA-1000_e.book 42 ページ ２００３年８月６日 水曜日 午前１１時５２分