Filter
Top Products
30
Basic connections and settings
Capturing sound from an external ADAT device
fig.basic
●
Connections
Connect an optical cable to the OPTICAL IN jack.
●
Sampling frequency select switch
Select either 44.1 kHz or 48 kHz.
Set this to the same sampling frequency as specified for your ADAT or recording software.
●
ADAT mode switch and external clock switch
fig.adat-sig
Simultaneously press the
ADAT mode
switch
and
external clock switch
.
The PEAK/SIG/ADAT IN indicators
will light orange simultaneously.
fig.adat-sig2
When audio signals are input from the
ADAT to the UA-1000, the PEAK/
SIG/ADAT IN indicators will light
green.
* If the word clock input connector is connected, the word clock input connector will take priority for
synchronization. In this case, the ADAT connected to the digital input connector must also be synchronized
to the word clock.
Optical cable
OUTPUT
OPTICAL IN
Set the sampling
frequency
Lit (orange)
Press simultaneously
Lit (green)
UA-1000_e.book 30 ページ ２００３年８月６日 水曜日 午前１１時５２分