Filter
Top Products
29
Basic connections and settings
Recording onto an external ADAT device
fig.adat-out
●
Connections
Connect an optical cable from the OPTICAL OUT jack.
●
Sampling frequency select switch
Select either 44.1 kHz or 48 kHz.
●
ADAT mode switch
Press the
ADAT mode switch
to turn it on.
* By pressing the
external clock mode switch
in ADAT mode, you can use ADAT Output mode to
synchronize the word clock or digital input to an external device.
Optical cable
INPUT
OPTICAL OUT
If you turn on the external synchronization mode switch when using ADAT output mode, the output to the
ADAT will be synchronized to the word clock from the external device or to the clock of the digital input.
fig.adat-out2
* If the word clock input connector and the digital input connector are both connected, the word
clock input connector will take priority for synchronization.
INPUT
OPTICAL OUT
WORD CLOCK IN
UA-1000_e.book 29 ページ ２００３年８月６日 水曜日 午前１１時５２分