Filter
Top Products
V
The product should be serviced by qualified service personnel
when:
● The power supply cord or the plug has been damaged.
● Objects have fallen, or liquid has been spilled into the product.
● The product has been exposed to rain.
● The product does not appear to operate normally or exhibits a
marked change in performance.
● The product has been dropped, or the enclosure damaged.
Do not wipe the product with benzene or thinner.
Doing so may result in discoloration or deformation of
the product.
When cleaning the product, put a soft cloth in
lukewarm water, squeeze it well, then wipe the
product.
To reduce the risk of injury, close supervision is necessary
when a product is used near children.
This product should be used only with the stand that is
provided by the manufacturer.
Should an abnormality occur in the product, immediately turn
the power OFF, disconnect the power cord plug, and
then contact the shop from which the product was purchased.
CAUTION:
To prevent electric shock, match wide blade of plug to wide slot, fully
insert.
ATTENTION:
Pour éviter les chocs électriques, introduire la lame la plus large de
la fiche dans la borne correspondante de la prise et pousser jusqu'au
fond.
Do not stand on the product or exert
excessive force.
Doing so may cause the product to become
deformed or fall over, resulting in breakdown
or injury.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a different electrical circuit from the
receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Canadian Radio Interference Regulations
This instrument complies with the limits for a class B digital apparatus, pursuant to
the Radio Interference
Regulations, C.R.C., c. 1374.