Filter
Top Products
The Driver Manager
67
Figure 143: Setting the Number of Command Rows
You can change the number of rows at any time.
2. Enter the command data according to the protocol:
For example, a certain LCD Display command format is:
[Command1][Command2][ ][Set ID][ ][Data][CR]
Data ranges from 0 to 64.
The specific command for the Volume Control (for a Data value of 35) is:
[k][f][ ][Set ID][ ][Data][Cr]: “kf 1 ”,0x35,0x0D.
3. Click the Command Data area and write the command to the Driver Table:
Figure 144: Entering a command