Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
The Driver Manager
68
4. Add the following commands.
If the data range in this example is from 0 to 64, you can gradually change the data in steps
1
(for
example, 0, 5, 10, 15 and so on):
Figure 145: Writing the Commands
You can now enable or disable specific commands, as needed (for example to set the rate of
increase or decrease of the volume) by selecting which commands should be used when traveling
UP/DN in the table with the relevant K-Config Action commands:
For example, select every 3 rows:
Figure 146: Selecting Every 3 Rows
1
If you find that you have not selected the exact number of rows, you can add or delete a row at any time