Filter
Top Products
20
Getting Ready
Placing the ATELIER on the Stand
If you place the ATELIER on a stand, you must use the KS-G8 or the KS-12 (sold separately).
NOTE!
• When placing the ATELIER on the stand, be careful not to pinch your ngers between the instrument and the stand.
• When lifting the ATELIER onto the stand, make sure to enlist the help of at least one other person.
• Using the ATELIER with any other stand may produce an unstable situation, possibly causing the instrument to fall or overturn, and resulting in
injury or damage.
• For details on how to assemble the stand, refer to the owner’s manual that accompanied the stand.
Placing on the KS-G8
A
B
C
Front (keyboard) side
Rear panel side
A
C
B
Top view
D D
1. Place the ATELIER in the position shown in the illustration.
• Position rubber feet “A” on the outside of the stand’s rubber pads.
• Position rubber feet “B” directly above the stand’s arms.
• Position rubber feet “C” so that they contact the inside of the stand’s rubber pads.
* Make sure that the ATELIER’s eight rubber feet (A–D) are not resting on the stand’s rubber pads.
Placing on the KS-12
D D
Front (keyboard) side
Rear panel side
Top view
1. Place the ATELIER in the position shown in the illustration.
Position rubber feet “D” so they t inside the holes on the stand.