Filter
Top Products
13
MT-90U Basic Operation
Once the connections have been completed (p. 12), turn on power to your various
devices in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
Turning the power on
1.
Set the volume to its lowest level by turning the [Volume] knob all the way to the left.
Turn down the volume and then turn on the power.
Even when the volume is turned down completely, you will hear a sound when the
power is turned on. This is not a problem.
<fig.00-02.eps>
2.
Press the [Power] button to turn on the power.
<fig.00-03.eps>
Adjust the volume to an appropriate level after turning on the power.
To protect the circuits, the MT-90U does not operate for a short time after the power is
turned on. This unit is equipped with a protection circuit. A brief interval (a few seconds)
after power up is required before the MT-90U will operate normally.
Turning the power off
1.
Set the volume to its lowest level by turning the [Volume] knob all the way to the left.
<fig.00-02.eps>
2.
Press the [Power] button to turn off the power.
If you are not going to use the MT-90U for a while, remember to disconnect the USB
device (memory, floppy disk or CD drive) to prevent it from being bumped or damaged
during transport.
Turning the Power On and Off
NOTE
Power
NOTE
MT-90U_r_e1.book 13 ページ ２００８年３月２４日 月曜日 午後４時４６分