Filter
Top Products
80
Use MIDI functionality
Specifying the location of the data
Here’s how to specify the location and data type of the variable portion (data) within a system
exclusive message.
The range of data values will be the default range in the case of Basic mode or Advanced mode
3. In the case of Advanced modes 1 and 4, you can specify the range of data values.
For an actual example, please read the Sys Ex. ASSIGN section
Master Volume
(p. 83).
1.
Press the
[DATA]
key at the location where you want to input the data.
The display will indicate “DT0”.
2.
Use the
[0]
–
[4]
keys to select the type of data.
* In the case of DT1–DT4 (data consisting of two or more bytes), a data area will automatically be allocated
for the next byte, and “-DT” will be displayed. (This cannot be changed.)
3.
Press the
[ENTER]
button.
4.
If you selected DT1 through DT4, the display will indicate “-DT”.
Press the
[ENTER]
button.
Data
number
Data type Default range Target of range setting
Example
(specified upper/lower limits)
DT0
7bit
00H–7F