Filter
Top Products
93
System settings
Here’s how you can make various system settings for the PCR-1.
fig.edt2
1
Press the
[EDIT]
button.
The display will indicate “EDT”.
fig.sy0
2
Press the
[SYSTEM]
key.
The display will indicate “SY0”.
3
Use the
[0]
-
[8]
,
[A]
-
[E]
keys to specify the System setting that you want to set, and then
press the
[ENTER]
button.
Confirm what’s indicated and use the appropriate method to make the setting.
Mode
Key-
board
Content of the setting Default
Setting
method
F8 CLOCK ON/OFF
0 Specify whether F8 Clock is to be transmitted. OFF p. 94
F8 CLOCK DEFAULT
TEMPO
1
If “F8 CLOCK ON/OFF” is ON, specify the default value
of the F8 Clock. After the power is turned on, this tempo
will continue to be output until you move a controller to
which TEMPO is assigned.
120 p. 94
F8 CLOCK PORT SET 2
If “F8 CLOCK ON / OFF” is ON, specify the port from
which the F8 Clock is to be transmitted.
PORT 1 p. 94
VELOCITY OFFSET 3
The value you specify here will be added to the velocity of
the notes played from the keyboard.
* If the result of the addition would exceed 7FH, the velocity will
be 7FH.
0
p. 94
KEYBOARD PORT
SET
4
Specify the port from which messages produced by the
BENDER lever of the keyboard are to be transmitted.
PORT 1 p. 94
H-ACTIVITY ON /
OFF
5
Turn this ON if you are using certain applications (such as
Pro Tools LE).
When ON, “90 00 7F” will be output from PCR 2 approxi-
mately every 500 ms.
OFF
p. 95
USB MIDI DRIVER
MODE
6
Specify the type of USB MIDI driver used for USB connec-
tion.
* The setting will take effect the next time you turn on the power
Original
Driver
p. 95
STARTUP MEMORY 7
Specify the memory that will be selected when the power
is turned on.
GM2 p. 95
FACTORY RESET 8
Restore all settings of the PCR-1 to their factory-set condi-
tion.
- p. 95
USB AUDIO ON /
OFF
A
Switch the USB AUDIO functionality ON / OFF.
The setting will take effect the next time you turn on the power
ON
p. 96
USB AUDIO MODE
SETTING
B
Specify the USB AUDIO sampling frequency and driver
mode.
* The setting will take effect the next time you turn on the power
44.1kHz
(AD-
VANCE)
p. 96
DIRECT MONITOR
ON / OFF
C
Make Direct Monitor settings (Sending the input signal
from the audio input jacks directly to the PCR-1’s head-
phone jack).
ON p. 97
PITCH BEND TIME D
Specify the time it is to take for the maximum pitch bend to
be reached after you press the bender switch. Higher set-
tings for this value produce a slower pitch bend.
2 p. 97
MODULATION SET-
TING
E
Specify the value of the
Modulation message
(CC#01)
transmitted when you press the
Modulation Button
.
127 p. 97
PCR-1_e1.book 93 ページ ２００３年１１月２０日 木曜日 午後３時２２分