Filter
Top Products
r
E-200/E-100
12
Using the Main and Split parts
(1) If you wish to play different sounds with your left and
right hands, press the [SPLIT] button.
The icon appears and the E-200/E-100 now automati-
cally selects a sound for the Split part that complements the
sound assigned to the Main part.
(2) Play a few notes on the keyboard.
At first, the keyboard is split at the C4 (note number “60”). If
necessary, you can select a different split point. See
“KeySplit* (Split point)” (p. 38).
To change the balance between the Main and Split sounds,
proceed as follows:
(3) Hold down the [SPLIT] button and use BALANCE [ACCOMP]
(decrease) or [KEYBOARD] (increase) to change the Split
part’s volume.
(4) To assign another sound to the Split part, hold down the
[SPLIT] button and proceed like for the Main part
(page 11).
Alternatively, press and hold one of the eight TONE buttons
(Main part) while pressing another TONE button (Split part).
Note: You cannot assign Drum Kits to the Split part.
Note: You can also add a monophonic bass part (“Auto Bass”) to
the Split part. See “Auto Bass*: status and volume” (p. 39).
Using the Main and Dual parts
(1) If you wish to play two sounds simultaneously, press the
[DUAL] button.
The icon appears and the E-200/E-100 now automati-
cally selects a sound for the Dual part that complements the
sound assigned to the Main part.
You can also activate the Dual mode by holding down one of
the eight TONE buttons while pressing another. The first
TONE button’s sound is then assigned to the Main part, while
the second sound is assigned to the Dual part.
(2) Play a few notes on the keyboard.
To change the balance between the Main and Dual sounds,
proceed as follows:
(3) Hold down the [DUAL] button and use BALANCE
[ACCOMP] (decrease) or [KEYBOARD] (increase) to change
the Dual part’s volume.
(4) To assign another sound to the Dual part, hold down the
[DUAL] button and proceed like for the Main part
(page 11).
Note: You cannot assign Drum Kits to the Dual part.
Using the metronome
You can switch on the metronome when practising a new song.
(1) Press the [METRONOME] button.
The icon appears in the display and you hear the metro-
nome sound.
(2) Press and hold [METRONOME] to select the Metro TS
function.
(3) Use the [NO/–]/[YES/+] buttons to set another time signa-
ture.
The possibilities are: 1/4, 2/4, 3/4, 4/4, 5/4, 6/4, 6/8, 9/8.
(4) Press another “big” button in the DATA ENTRY section to
leave this function.
(5) Press the [METRONOME] button again to switch the met-
ronome off.
SPLIT
SPLIT
Split Main
BALANCE
ACCOMP KEYBOARD
SPLIT
DUAL
DUAL
METRONOME
E-200_US Page 12 Tuesday, January 27, 2004 4:01 PM