Filter
Top Products
Internal Design of the CP5 & CP50
Reference
Left & Right Parts
[VOICE]
[PRE-AMP]
[MOD-FX]
[PWR-AMP] (CP5 only)
[LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
[COMMON]
Song Setting Area
[SONG SETTING]
[RECORD]
TRACK Part
[TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
Settings for All Parts
[REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
[UTILITY]
[FILE]
Appendix
34 CP5/CP50 Reference Manual
Setting Controllers (Pages 3 to 5)
Edit Sequence
Press the [COMMON] button Navigate to Page 3, 4, or 5 using the [ PAGE] and
[PAGE
] buttons Turn Knobs 1 to 3
Page
On-screen name
(and full name)
Description
Pages
3 to 5
Source This parameter is used to select the controller to be edited.
Setting values:
CP5 Performances:
PB (Pitch Bend wheel), FC1 (Foot Controller 1), FC2 (Foot Controller 2),
FS (assignable foot switch)
CP50 Performances:
PB (Pitch Bend wheel), FC (Foot Controller), FS (assignable foot switch)
FC1 or FC2 (CP5) / FC (CP50)
Foot controller(s) connected to the FOOT CONTROLLER jack(s)
FS
Foot switch connected to the ASSIGNABLE jack
3
CP5:
L1Dest (LEFT1 Destination)
L2Dest (LEFT2 Destination)
CP50:
LDest (LEFT Destination)
These parameters are used to assign the controllers selected using
Source with a function for the corresponding part.
Setting values: As follows.
NOTE If “modFx” is selected as a destination with Source set to “PB”,
“FC1”, “FC2”, or “FC”, you can then use the corresponding
controller to adjust one of the parameters from the Modulation
Effect block up or down with respect to the current setting. For
details on the actual parameter that will be assigned, see the
Modulation Effect block's parameter list in the Data List pdf
document. Specifically, the parameter marked
in the Control field
will be assigned to the controller.
NOTE If Source is set to “FS”, the function assigned as the destination can
be turned on and off by pressing the controller in question. If the
destination is specified as “vibrato”, “modFx”, or “pwrAmp”,
pressing the controller will have the same effect as pressing the
[PRE-AMP], [MOD-FX], or [PWR-AMP] button. For details on how
this will affect the sound, refer to the Quick Guide section from the
Owner’s Manual booklet.
4
CP5:
R1Dest (RIGHT1 Destination)
R2Dest (RIGHT2 Destination)
CP50:
RDest (RIGHT Destination)
5 Mode (Switch Mode) This parameter is available only when Source has been set to “FS”. It is
used to specify whether the controller in question will operate as a
latch-type or momentary-type switch. Latch-type switches remain on or
off after being operated, while momentary-type switches remain on only
while they are being operated.
Setting values: momentary or latch
Source Destination
PB (Pitch Bend) off or modFx (modulation
effect)
FC1 or FC2 (CP5 Foot Control-
ler 1 or 2) / FC (CP50 Foot
Controller)
off, volume, or modFx
FS (assignable foot switch) off, vibrato, modFx, or
pwrAmp (CP5 only)