Filter
Top Products
CHAPTER 1: Getting Started
18
Continue to next page...
English
Resetting the Pocket Controller
When rebooting cannot be performed or the Pocket
Controller does not work correctly even after rebooting,
follow the procedure below.
1 Turn the Disklavier off.
(→ pg. 6 “Turning the Disklavier Off (Standby
Mode)” in “Quick Guide”)
2 Connect the AC adapter to the AC adaptor jack, and
then set the battery replacement switch to the
[REPLACE BATTERY] position.
3 Wait for five seconds, remove the battery
compartment lid, and then press the [RESET] button
with the stylus pen.
4 Replace the battery compartment lid, and then set the
battery replacement switch back to the [NORMAL
OPERATION] position.
5 Press to turn the Pocket Controller on.
The [Main] screen appears after approximately two
minutes.
NORMAL OPERATION
REPLACE BATTERY
RESET
Pairing the Pocket Controller and the
Disklavier
For normal use, this setup is not required.
1 Make sure that other wireless equipment is turned off.
2 Tap on [Piano Assign] in the [PRC-100 Menu]
screen.
3 Move the Pocket Controller close to the Disklavier,
and then tap on .
4 Tap on .
5 Tap on on the [Assigned successfully] screen.
The [PRC-100 Menu] screen resumes.
Note: Do NOT abort the procedure before step 4.
Otherwise you cannot control the Disklavier.
ESS-ID number