Filter
Top Products
CHAPTER 6: Other Settings
61
If you connect the Disklavier to an audio system, you can
hear the sound played/played back on the Disklavier from
the connected audio system, and the sound played back
on the connected audio system from the Disklavier.
You can select the kind of the incoming/going out audio
signals. The following options should be set up in
advance.
[OMNI IN]
Selects the appropriate option to match the incoming data
input to the [OMNI IN] jacks.
[Audio]: Select this when you play back an audio
software on the connected CD player, etc.
and reproduce the sound from the Monitor
speakers*.
[Analog MIDI-YM]:
Select this when you play back
PianoSoft·PlusAudio song.
Note: While this option is selected, you
cannot adjust the [ONMI IN Vol] value,
and Video Synchronized Playback and
Vocal Harmony Mode is not available.
[OFF]: Select this when you cancel the data
reception from the [OMNI IN] jacks.
[OMNI OUT]
Selects the desired data to be output from the [OMNI
OUT] jacks.
[Output]: Select this when you output the same audio
signals as the ones for the Monitor
speakers*.
[Output+PianoTG]:
Select this when you output the ensemble
part and the digital piano sound. (Note that
the digital piano sound is also output in
Acoustic mode.)
[PianoTG]: Select this when you output only the digital
piano sound.
[OFF]: Select this when you cancel the data
transmission from the [OMNI OUT] jacks.
Hooking Up AV Equipment
DIGITAL
OUT
DIGITAL
OUT
AV amplifier, CD player, etc.
To audio
inputs
To audio
outputs
To digital audio
inputs
RCA cord
(not
supplied)
Coaxial digital
audio cord (not
supplied)
I/O Center
Setting Up the Disklavier for
Audio Data Reception/
Transmission