Filter
Top Products
44
Registration Memory
3
Register the Settings..........................................................................................................................
While holding the [MEMORIZE] button, press one of the REGISTRA-
TION MEMORY buttons. Any data that was previously in the selected loca-
tion is erased and replaced by the new settings. The corresponding Registra-
tion Memory number will appear above “REGIST” in the display.
• The Registration Memory data,
including the registration name,
is retained in memory even when
the power switch is turned OFF
as long as the batteries are
installed or the AC adaptor is
connected. It is nevertheless a
good idea to save important
registration data to floppy disk so
you have a backup in case of
accidental erasure (see page
66).
ACCOMP
FREEZE
REGISTRATION
MEMORY
MEMORIZE 1 2 3 4
● Enter a New Name for the Registration Bank
If you want to enter a descriptive name for easier identification, enter
your original Registration Bank name, this is recommended.
Use the cursor [>] button to move the cursor to the first (left most)
character of the Registration Bank name in the display. A Registration
Bank name can consist of up to 8 characters. The position of the charac-
ter you want to enter or change can be selected by moving the cursor.
Using the [–/NO] and [+/YES] buttons or the data dial, enter the de-
sired character listed below. The number buttons can also be used to en-
ter the number. If you want to insert an underline character at the cursor
position, press the cursor [▲] button. If you want to delete a character at
the cursor position, press the cursor [▼] button. When you’ve finished
entering the Registration Bank name, move the cursor to the position
other than the Registration Bank name so that the newly entered Regis-
tration Bank name will be memorized.
Yamaha
101
Character List
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789–
• Please note that anytime you
store to a REGISTRATION
MEMORY button, all settings
previously stored in that button
will be erased and replaced by
the new settings.