Filter
Top Products
102
Changing the Effects
The RY20 contains a built-in DSP that is capable of a wide variety of
reverb and delay effects.
If you have a rack of reverbs, delays, and other effects devices, you
may want to use just the drum sounds of the RY20. The first display
page of the Effect Mode allows you to quickly and conveniently bypass
the DSP effects, switching from a “wet” sound to a “dry” sound.
1
Put the RY20 in Effect Mode by pressing the [EFFECT] button. Notice that
the “EFFECT” indicator is switched on as is the “EFFECT” prompt and that
the current setting is flashing.
2
Switch from effect “ON” to effect “BYPAS” (bypass) by rotating the Jog Dial
or by using the [ +1 ] and [ –1 ] buttons.
The RY20 is shipped with the Effect Mode “ON”. This setting applies to all
the Drum Kits.
10
Changing the Effects
■ Enabling Effects
NOTE
From the initial display page of the Effect Mode, pressing the
[EFFECT] button will
switch the RY20 back to the previously selected main mode, such as Pattern or Song
Play Mode or one of the recording modes.
From the other display pages of the Effect Mode, pressing the
[EFFECT] button will
switch to the initial display page of the mode.
EFFECT
PATTERN EFFECT
A CHASE
MAIN A
PAD BANK
OTHERS
HH
SD
BD
+
–1 +1