Filter
Top Products
VL Version 2
7
NOTES ■ For detailed MIDI specifications refer to the “MIDI Data Format”
section in the “Voice Lists & MIDI Data for Version 2” document.
■ When using the VL1-m Ver.2 with other MIDI equipment, it is a good idea to
refer to the MIDI specifications (implementation chart, MIDI data format) of the
equipment used to ensure compatibility.
Load the Pre-programmed Voice Data
Although the factory pre-programmed voices are stored in the instrument’s internal
memory when it is initially shipped, there is always a possibility that all or part of the
memory has been erased or modified by the time the instrument gets to you. It’s a good
idea to re-load all the pre-programmed data from the supplied “FACTORY SET” voice
disk, as follows.
NOTES ■ Loading the pre-programmed voices overwrites any other data that is
in the internal memory, so if you have any important voices in memory make
sure they are safely saved to disk before loading the data, as described in the
Feature Reference manual:
VL1. . . . . . . page 166
VL1-m . . . . page 166
VL7. . . . . . . page 166
1. Insert the Voice Disk
Insert the Version 2 voice disk into the disk drive. The sliding disk shutter should
go in first, and the label side of the disk should face upward.
2. Select the Utility Mode System Page
Press the U button to select the utility mode. Then, if it is not already se-
lected when the utility mode display appears, press the ¡ button to select the “Sys-
tem” function page.
NOTES ■ If the Memory Protect function has been turned on (the default
setting is “off”), it must be turned off before loading the data.
Use the cursor buttons to move the cursor to “Miscellaneous”, then press
[
to call the “Miscellaneous” function page. Use the cursor buttons to
select the “Memory Protect” parameter, then press
=
to turn memory
protect “off”.
1: Initial Setup