Filter
Top Products
VL Version 2
9
7. Return to the Play Mode, Eject the Disk, & Select a Voice
When the “Completed!” display appears, press the P button to return to the
play mode, then press the eject button below the disk drive slot to eject the disk. Store
the disk in a safe place. You must now select a voice in order for the loaded data to be
properly activated — see the following section.
About the Version 2 Data Disk
The Version 2 floppy disk contains the following files:
NOTES ■ These voice files cannot be used with the original VL models.
● VL1_VER2.ALL
This file contains the voices initially loaded into the VL1 Version 2
when it is first shipped from the factory. The UTILITY/SYSTEM/BREATH
MODE parameter is set to “Touch EG”, so until this is changed to “BC/
WX” the breath controller or a WX wind controller cannot be used.
Many of these voices can also be used on the VL7 Version 2.
● VL1V2_WX.ALL
The 32 voices included in this file have been programmed specifically
for optimum playability on the VL1 Ver.2 or VL1-m Ver.2 using a Yamaha
WX-series wind controller (WX7/WX11).
This selection also includes many voices which can be effectively
played via a keyboard with breath control. Many voices are suitable for the
rock and pop genres, so don’t overlook them for keyboard control.
● VL7_VER2.ALL
This file contains the voices initially loaded into the VL7 Version 2
when it is first shipped from the factory. The UTILITY/SYSTEM/BREATH
MODE parameter is set to “Touch EG”, so until this is changed to “BC/
WX” the breath controller or a WX wind controller cannot be used.
● VL7V2_WX.ALL
The 32 voices included in this file have been programmed specifically
for optimum playability on the VL7 Ver.2 using a Yamaha WX-series wind
controller (WX7/WX11).
This selection also includes many voices which can be effectively
played via a keyboard with breath control. Many voices are suitable for the
rock and pop genres, so don’t overlook them for keyboard control.
● ADDITION.ALL
This file includes some excellent voices that are not in the
VL1_VER2.ALL or VL7_VER2.ALL files. Most are single-element voices,
so the VL1 voices can be used effectively on the VL7.
1: Initial Setup