Filter
Top Products
VL Version 2
16
2. Select the Utility Mode System Page
Press the U button to select the utility mode. Then, if it is not already
selected when the utility mode display appears, press the ¡ button to select the
“System” function page.
NOTES ■ On the VL1 Ver.2 and VL7 Ver.2 you can move the cursor to “Assign-
able Ctrl” and press
[
to see the current control assignments for the
various controllers. Press
]
when you’re ready to go back to the previous
page.
■ On the VL1-m press the
¶
(Moni) button to monitor the MIDI data received
from the controllers. Press
]
to return.
3. Set the Breath Mode to “BC/WX”
Use the cursor keys to move the cursor to “Breath Mode”, and press
[ to call the “Breath Mode” function page. If the “Mode” parameter is not
set to “BC/WX”, make sure the cursor is located at the “Mode” parameter and use
the = and - buttons to select “BC/WX”. Press ] to return to the previ-
ous page.
4. Go To the Curve Page and Select “Brth”
Use the cursor keys to move the cursor to “Curve”, then press [ to call
the “Curve” function page. On the VL1 Ver.2 and VL7 Ver.2 press the •
function button (“Brth”) to call the breath controller curve page when the curve
display appears. On the VL1-m Ver.2 it is only necessary to select “BC Curve”.
5. Adjust the Breath Controller Offset
The following adjustment must be performed while not blowing into the
breath controller mouthpiece. Do not hold the breath controller in your mouth.